31234 Moto Guidebody White

• 30 square feet of surface area.
• 6" outside diameter x 10" height x 1 7/8" inside diameter. 

1. Open or remove the spa cover.
2. Using a large flat blade screwdriver, carefully remove the two screw covers located at the top and bottom of the
3. Moto faceplate slot.
4. Unscrew the faceplate retainer screws and remove the faceplate.
5. Remove the four retainer screws holding the Moto guidebody in place. Make sure to denote the location of the screws for reinstallation.
6. Remove the guide body.
7. Reaching into the Moto niche, locate the small air tube and slide the o-ring and tube off of the small barbed fitting.
8. With your hand still in the Moto niche, grasp the Moto
9. Massage vertebrae located closest to the rear of the niche.
   Important: Do not grasp any other vertebrae as damage to the Moto assembly may occur.
10. Slowly unscrew the Moto Massage from the niche by turning the assembly counter clockwise.
11. To reinstall the Moto Massage, reverse steps 1 to 7.

Important Instructions Regarding Moto Massage Alignment:

In order the for the Moto Massage to operate properly it is imperative that the Moto Massage nozzle be properly positioned after the assembly is tightened in the Moto niche.

To properly align, ensure that the two holes located on the nozzle face are position horizontally and that the Moto assembly travels vertically within the niche.